2025-03-19T09:53:06.507Z - Using Microsoft Flight Simulator X
2025-03-19T09:53:06.507Z - Flying Airbus A330-200 KLM 100 years - TR
2025-03-19T09:53:06.507Z - Now boarding
2025-03-19T09:53:06.508Z - COM1: 120.700, COM2: 127.800, NAV1: 110.30, NAV2: 110.60, Transponder: 1200
2025-03-19T09:54:17.871Z - Pushing back with 33430 LBS of fuel
2025-03-19T09:54:37.953Z - Engine 1 On
2025-03-19T09:55:03.066Z - Engine 2 On
2025-03-19T09:55:25.145Z - Taxiing out
2025-03-19T10:00:37.467Z - Flaps set to 20%
2025-03-19T10:00:51.508Z - Flaps set to 40%
2025-03-19T10:05:21.801Z - Taking off
2025-03-19T10:05:39.943Z - Climbing at 171 kts, 3 degrees pitch, -0 degrees bank
2025-03-19T10:05:42.965Z - Gear lever raised
2025-03-19T10:05:43.967Z - Flaps set to 20%
2025-03-19T10:05:51.002Z - Flaps set to 0%
2025-03-19T10:19:13.998Z - Cruising at 23000 FT
2025-03-19T11:11:13.156Z - Descending with 37 nm to go
2025-03-19T11:18:48.679Z - Approach started at 8412 FT AGL with 36 nm to go
2025-03-19T11:22:50.782Z - Flaps set to 20%
2025-03-19T11:23:42.121Z - Flaps set to 40%
2025-03-19T11:24:10.297Z - Flaps set to 60%
2025-03-19T11:32:36.623Z - Using Microsoft Flight Simulator X
2025-03-19T11:32:36.623Z - Flying Airbus A330-200 KLM 100 years - TR
2025-03-19T11:32:36.623Z - Flaps set to 0%
2025-03-19T11:32:36.623Z - Paused
2025-03-19T11:32:36.624Z - Approach started at 148 FT AGL with 478 nm to go
2025-03-19T11:32:36.624Z - COM1: 120.700, COM2: 127.800, NAV1: 110.30, NAV2: 110.60, Transponder: 1200
2025-03-19T11:32:37.624Z - Unpaused
2025-03-19T11:32:37.624Z - Touched down at {landingRate} fpm, {gForceTouchDown}g, 0 kts, -1 degrees pitch, -0 degrees bank
2025-03-19T11:32:37.624Z - On ground 478 nm from planned arrival airport
2025-03-19T11:32:39.627Z - Taxiing to gate, landed in 0 FT
2025-03-19T11:34:51.515Z - Comment: FSX did a CTD during approach at the "Flaps set to 60%" above.... restarted sim at origin airport and will time advance to point of descent and normalize time there.... will see how SC3 treats this and if it will issue a new touchdown reading for the actual landing.
2025-03-19T12:22:39.669Z - Comment: Even though SC3 recognized the reconnection it didn't log any actions past that point..... Was able to successfully land at the airport, however, FSX acted like it was about to crash again so think I have a scenery problem in this part of the world. Hopefully I'll be able to take off OK from here on the next leg. Filing this as a manual PIREP but at least all of the original actions are tracked up to the point of crash shortly before I would have landed.